Z axis Alu upgrade – back aluminium sliders installation

Aluminium Z axis upgrade for Scalar L / XL Premium

Left side assembly (X axis motor side)

machoire aluminium pour imprimante 3D Scalar

montage_5.jpg?raw=true


Right side assembly

Setup your Firmware parameters

The TR10x2 trapezoïdale leadscrews requires new ZStep/mm settings on your firmware

Through your LCD display,go to Control>movements>Zstep/mm>1600

Trap lead screws requirements

Make sure to lubricate the leadscrews as well as your Igus nuts using PTFE lubricant, grease, or even Fine oil for small mecanism