How to assemble Titan extruder
The official documentation is provided here
https://wiki.e3d-online.com/wiki/Titan_Assembly
Compact Mode
The plastic support is available for free download on Thingiverse
You will need:
- 4 Screws M3x10 thermo
- 6 Screws M3x8 thermo
Compatibility mode
Important Notes
- Before anything else, make sure that the « small » cylinder is installed inside the extruder with the small plastic connector facing down.
- Also make sure that you are using the proper plastic part located above the cylinder. It must fit your filament diameter. There is a marking under the plastic part giving you the filament diameter.
- If using 1.75mm filament, make sure you have the PTFE Tube installed up to the end of the hotend. The part of the tube that goes out of the hotend must also go into the plastic part installed above the cylinder.
The plastic support is available for free download on Thingiverse
You will need:
- 2 Screws M3x10mm Thermo
- 3 Screws M3x35mm
- 1 Screws M3x20mm