Check the PDF 3D to get a global view of the assembled chassis of the Scalar S
-
PDF 3D : Global view of the chassis
Building the chassis
- 3 2020 40cm extrusion profiles
- 2 v-slot Profiles2020 40cm (for Z Axis)
- 2 Extrusions profiles 2020 30cm
- 6 small squares
- 2 Double squares
- 20 pcs M4x8 screws
- 20 Pcs M4 TNuts
Use 6 small squares and pre mount the screws and TNuts
Do the same for the double squares
Tip
Move the squares on the corners. Yhe Tnut must be aligned with the extrusion profile groove.
Once properly aligned the TNuts will properly fit the groove and the square will naturally take it’s place
When you will tighten the screw, the Tnut will perfom 1/4 turn inside the extrusion profile as shown on the picture.
Check carefully that the TNut has performed the 1/4 turn so it’s properly locked with with extrusion.
Make sure the Tnut is properly positioned before finalizing your build.
When you unscrew the screws, the TNut must unlock and perform 1/4 turn on the other side. This will allows you to remove the square and the nut.
Chassis base
For the base of the chassis, you will need to use only 2020 standard extrusion profiles. Keep the Vslot (often black) extrusions for later.
Z Axis
The extrusions on both sides (here on the right and on the left) Are VSlots (often black)
The top extrusion profile is standard 2020 extrusion
Assembling both parts
Finish
List of parts
- 6 end caps
use the 6 end caps as shown on the picture.
Start to push them by hand slightly.
Push them up to the end. use some force if needed. You may require an hammer to push them completely in some cases.